This device is located in Mechanical Laboratory which is used to do the tensile, compression, and bending test of samples that are cut from cylinders.

The following description shows how the device works:

First, a sample will be taken from the cylinder which has been heated, is separated according to the ECE R110 standard.

Then the tensile test starts after installing the extensometer on the sample and putting the sample between the edges of the device and entering the pattern values to the related software and the sample will go under tensil.

Next, after a specific time the sample is like a neck shape and will be free.

The device software calculates surrender to device, tensile strength and elongation percentage and displays the information

on the screen. 

After comparing the shown parameters with the ECER110 requirements standard, the report will be sent to to the Quality Control section.